The Lutron DO Meter Calibration Solution OXEL-03 is a standard calibration solution used to calibrate dissolved oxygen (DO) meters, particularly those made by Lutron, such as their OX-100 series. Calibration solutions like the OXEL-03 are critical for ensuring accurate and reliable readings from DO meters, which are typically used in water quality monitoring and environmental testing. Probe-Filling Electrolyte OXEL-03. \n \nHere’s some useful information about the Lutron OXEL-03 calibration solution: \n

Key Features of DO Meter Calibration Solution OXEL-03:

\n

\n
1. Composition: The OXEL-03 solution is designed to simulate specific levels of dissolved oxygen (DO) in water, allowing the user to adjust the DO meter’s readings to match those of a known standard. It typically has a set DO concentration (often 100% saturation) that corresponds to specific temperature and pressure conditions.
\n
2. Purpose: Calibration of the DO meter to ensure accurate readings, particularly when performing measurements in environments such as water bodies, wastewater treatment, or aquaculture where oxygen levels can vary.
\n
3. Concentration: The solution is typically pre-measured to a specific dissolved oxygen concentration that the meter can be adjusted to. In many cases, it is set to match 100% dissolved oxygen saturation at standard conditions (20°C, 1 atm).
\n
4. Packaging: Calibration solutions like the OXEL-03 come in pre-packaged bottles for convenience, and each bottle is generally intended for a single calibration procedure. This ensures consistency and reduces the chances of contamination.
\n

\n

Calibration Procedure:

\n

\n
1. Preparation: Fill a clean sample container with the calibration solution.
\n
2. Meter Setup: Turn on your Lutron DO meter and place the probe into the calibration solution.
\n
3. Adjust Calibration: Follow the instructions provided by Lutron for your specific meter model. Typically, you would adjust the meter reading to match the dissolved oxygen level of the solution (e.g., 100% saturation).
\n
4. Verification: After calibration, it's recommended to verify the accuracy of the meter by testing it in a known water sample or another calibration solution to ensure proper performance.
\n

\n

Why Calibration Is Important:

\n

\n
• Accuracy: Meters can drift over time due to sensor degradation, environmental conditions, or mechanical factors. Calibration ensures that the readings are accurate.
\n
• Environmental Monitoring: Accurate dissolved oxygen measurements are crucial in water quality analysis, especially for assessing the health of aquatic ecosystems or the effectiveness of wastewater treatment processes.
\n
• Regulatory Compliance: In many industries, accurate dissolved oxygen measurements are required for regulatory purposes.
\n

\n

Storage and Handling of DO Meter Calibration Solution OXEL-03:

\n

\n
• Store the calibration solution in a cool, dry place, away from direct sunlight and extreme temperatures.
\n
• Make sure to seal the solution container properly to prevent contamination and evaporation.
\n

\nIf you're using a Lutron DO meter, it's essential to refer to the specific user manual for instructions on how to properly calibrate with the OXEL-03 solution, as the procedure can vary depending on the model.

\n
• 50 ML DO Probe Solution
\n
• Model: OXEL-03
\n
• Made in Taiwan
\n