Requirements for certification of fixed electric photoelectric devices for instantaneous water intake.

For suggestions, please read the device manual

Attention!

Reas carefully the Instatation instruction before instaling the product Keep this manual for further reference in care needed. The installation of this equipment must be performed by a qualified profess

Preparing to install

Make sure the voltage of the shower head is adequale to the Voltage of the line which comes from the main swianboerd (220V- The unit must be installed to a great line whics comes from the man switchboard weing adequate catiles and a protecting device (prout breakers Such installation should take into consideration the voltage (volts) power rating (Watts) and distance tom the shower head to the softshooard according to the technical characteльtics latie. Use tive pole circull breaker to 220V- phase supply and a single pole sirsut breaker to 220V- (single phase supply Before stening the installation switch off the sirsut breaker farm the main switchboard where the shower unit will be

Hydraulic installation-tools can be used:

Connect the product to the pipe with no need of tools. 1/2 thread use an adaptor (not supplied). A tube and Open the water valve and let the water flow through must supply a minimum water pressure of 10kPa For water outlet less than 8 meters 8kPa water column, Inlet of your product Use a sealing tape in the water connecting the unit to the wires, let water run through fulfilled with water the heating element will not be While water runs through the unit, check if there are

In case the piping system dose not match with the glove are requested in order to install the product. out the tube to remove the dirt. The pipe system (1mca) up to a maximum of 400kPa (40mca 4bar) remove the reducer installed in the pipe of water inlet nipple of the unit, to avoid leakages. Before the product so that once the water chamber is damaged as a result of bad installation procedures. any leakage points and then close water valve

Installation of the hose holder support:

Install the bypass hose holder on the wall in a way that it dose not block the water to flow through it, and at a height easily reached by ones hand. Note: check the positions of the pipes placed into the wall just to make sure they are not be perforated during the installation process(pict.03).

To open or close the hose holder pull or push the pin (pict.02

Electrical installation:

Connect the unit to the wires (pict.04)and make sure the connectors used (not supplied) Match the right voltage and power rating of the electric circuit of the shower head.

The ideal height of the derivative box is 13cm above the water outlet.

Attention! do not use plugs neither sockets for the installation

Usage:

After connect the wires accordingly, the shower head will be ready to start working. Switch on the circuit breaker.

Place the selector's key in the position desired.

To change the power rating, close to water valve and place the temperature selector in the position desired. The water temperature can be controlled through water valve.

For your own safety and provide a longer life components of the unit, only use the selector's key when the water valve(register) is closed